WattFlyer RC Electric Flight Forums - Discuss radio control eflight

WattFlyer RC Electric Flight Forums - Discuss radio control eflight (https://www.wattflyer.com/forums/index.php)
-   Power Systems (https://www.wattflyer.com/forums/forumdisplay.php?f=17)
-   -   T-28 ParkZone ESC/Motor (https://www.wattflyer.com/forums/showthread.php?t=71741)

Fritzngertie 08-31-2013 05:32 PM

T-28 ParkZone ESC/Motor
 
I crashed my T-28 plane. I was flying straight and level when the plane started to act as if I was moving the rudder, elevator and aerliron in both directions rapidly and all at the same time. I could not control it and it crashed into the ground. Is it possible that the esc or motor could have overheated. I normally fly two aircraft alternating between them. This time, I didn't, I was on my second flight. The plane was out far enough that I could not hear the motor. I live in Florida and so there is plenty of heat. Also, with the cowling around the motor and esc I don't think much air flow gets in. Any comments would be welcome. This has happened to me before and I replaced the esc because it crashed into a small pond.

Thanks,

Don


All times are GMT +1. The time now is 10:00 AM.

Powered by: vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.06847 seconds with 9 queries