Search: Posts Made By: TexasSP
Showing results 1 to 10 of 10
Search took 0.00 seconds.
03-31-2008, 05:32 AM
Replies: 12
Views: 3,102
Posted By TexasSP

Thumbs up T Rex Choices 450 or 600?

I have the oppurtunity to pick up a T Rex 450SE V2 with carbon blades for $430 or a T Rex 600 GF Kit with the motor/ESC/BEC/RX Lipo for $420.

I have had the blade CX2 for a while and have...
03-30-2008, 06:34 AM
Replies: 7
Views: 1,225
Posted By TexasSP

This is only true if you over discharge them...

This is only true if you over discharge them typically below 2.7 volts per cell. All of my other RC's I run them in are set to cut off at 3 volts per cell. Lipo's are fine being charged down and...
03-30-2008, 06:27 AM
Replies: 33
Views: 9,006
Posted By TexasSP

I asked the same, and Sonny is www.bladecx2.com

I asked the same, and Sonny is www.bladecx2.com
03-20-2008, 04:44 AM
Replies: 4
Views: 1,748
Posted By TexasSP

www.mcmaster.com

www.mcmaster.com
03-18-2008, 04:06 AM
Replies: 11
Views: 2,476
Posted By TexasSP

The bumpy rotation by hand is most likely the...

The bumpy rotation by hand is most likely the magnets in the motors. The reason it would increase in the extreme motors is that they are higher performance and will have stronger magnetic pull. ...
03-14-2008, 04:51 AM
Replies: 7
Views: 2,000
Posted By TexasSP

Although I have not the experience in flying, I...

Although I have not the experience in flying, I do in land vehicles and the castle creations BEC is quite nice.

It puts out up to 10 amps, 4.8-9 volts, and is good up to 6s (25v)

It is also...
03-09-2008, 03:48 AM
Replies: 14
Views: 3,028
Posted By TexasSP

Well it looks like my flybar is bent for one. I...

Well it looks like my flybar is bent for one. I tried bending it back but to no avail. I did adjust the blade tracking per the manual and that helped a little, I will get a new flybar next and go...
03-09-2008, 12:21 AM
Replies: 14
Views: 3,028
Posted By TexasSP

CX2 Upper Rotor Heavy Vibration

I haven't used my CX2 in a while, and when starting it up today I noticed a lot of vibration. I took off the canopy and tail to isolate the two motors and discovered that the upper rotor vibrates...
03-06-2008, 12:02 AM
Replies: 33
Views: 9,006
Posted By TexasSP

Thanks for your reply and help. I am...

Thanks for your reply and help.



I am in the same boat as you and really my wife prefers I don't destroy the living room with my heli. I would like to move into a T-Rex later when I get the...
03-05-2008, 05:38 AM
Replies: 33
Views: 9,006
Posted By TexasSP

I was just curious of who sonny is and what all...

I was just curious of who sonny is and what all sonny sells?

I have had a CX2 for a year but have been disappointed with the discharge curve. Obviously I have found reading in this forum that the...
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.05257 seconds with 7 queries