Search: Posts Made By: Twmaster
Showing results 1 to 30 of 158
Search took 0.02 seconds.
05-02-2011, 07:47 AM
Replies: 36
Views: 4,837
Posted By Twmaster

Say folks, just a friendly poke at the nest... ...

Say folks, just a friendly poke at the nest...

Remember, discussion of politics is not allowed here. While I am just as happy as most of you with the news please, let's not wander off that topic.
06-23-2010, 07:32 PM
Replies: 14
Views: 1,928
Posted By Twmaster

Good job Bill! Sounds like your kids really...

Good job Bill!

Sounds like your kids really played their hearts out!

WOOT!
Replies: 13
Views: 4,129
Posted By Twmaster

How does a UBEC require two channels??? A...

How does a UBEC require two channels???

A UBEC -NEVER- connects to the signal lead. All of the rest of the black leads and red leads connect to each respective color. IT does not 'need' a...
Replies: 13
Views: 4,129
Posted By Twmaster

If I understand you it should be ok to do that....

If I understand you it should be ok to do that. However, if using the UBEC with an ESC that has a BEC you will need to remove the red wire from the ESC lead and insulate it

I'd also make sure you...
05-18-2010, 07:11 AM
Replies: 10
Views: 1,749
Posted By Twmaster

Scweet CC! I love German airplanes!

Scweet CC!

I love German airplanes!
Forum: Beginners
05-11-2010, 10:13 PM
Replies: 21
Views: 4,706
Posted By Twmaster

To reinforce what the others have said, rudder on...

To reinforce what the others have said, rudder on the right on three channel ships.

The idea is that the L-R directional control is on the right stick regardless of whether you are flying a rudder...
04-17-2010, 07:16 AM
Replies: 6
Views: 1,436
Posted By Twmaster

I just looked at your profile. You are using font...

I just looked at your profile. You are using font (Comic sans) and color (black) coding.

Try to remove the color first then try adding the new text. Or remove all references to the font and color.
04-17-2010, 06:33 AM
Replies: 6
Views: 1,436
Posted By Twmaster

Can you detail the error message?

Can you detail the error message?
04-01-2010, 07:08 AM
Replies: 26
Views: 5,547
Posted By Twmaster

Just doin' my job mam' {Mike tilts his hat...

Just doin' my job mam'

{Mike tilts his hat to the lady}

:D
Forum: Beginners
03-25-2010, 03:40 AM
Replies: 42
Views: 10,382
Posted By Twmaster

Depending on what I am looking for determines...

Depending on what I am looking for determines where I shop online.

For airplanes and such I like Atlanta Hobby (www.atlantahobby.com).

For small parts and other reasonably priced...
Replies: 3
Views: 2,203
Posted By Twmaster

It's going to take more than a simple LED to do...

It's going to take more than a simple LED to do that. There is a fellow selling backlight kits for the 9303. I'll see if I can dig up an email address or link for him.
09-11-2009, 05:36 AM
Replies: 50
Views: 7,228
Posted By Twmaster

This thread has run it's course. Time for closure.

This thread has run it's course. Time for closure.
Forum: Power Systems
09-04-2009, 09:28 PM
Replies: 32
Views: 6,727
Posted By Twmaster

Hey gang, Please let's keep this civil. This...

Hey gang,

Please let's keep this civil. This is not the place for cola wars....
Replies: 5
Views: 3,379
Posted By Twmaster

Ok, two problems. 1. The LP in the model...

Ok, two problems.

1. The LP in the model designation on that TX is for 'Low Power' IT really only has like 200 foot range.

2. AR6000 is DSM1. IIRC the LP5DSM does not do DSM1. DSM2 only.
...
08-09-2009, 08:15 PM
Replies: 45
Views: 9,938
Posted By Twmaster

Bub Steve... I admire your tenacity. Go...

Bub Steve...

I admire your tenacity. Go git'em!

I'm not doing well financially these days but let me know what parts I may be able to contribute.
08-07-2009, 03:43 PM
Replies: 13
Views: 2,065
Posted By Twmaster

Ok... Now this might be it... I'm not 100%...

Ok... Now this might be it...

I'm not 100% sure and don't have time to research this right now as I am already late for work...

I seem to recall some issues with trying to bind a DX6i with...
08-07-2009, 03:30 PM
Replies: 13
Views: 2,065
Posted By Twmaster

EDIT: That should have an AR6100E receiver. If my...

EDIT: That should have an AR6100E receiver. If my memory is right that light on the RX should flash rapidly when in bind mode.

Ok. Then it sounds like you have one of two things going on.

You...
08-07-2009, 06:56 AM
Replies: 13
Views: 2,065
Posted By Twmaster

That is possible. If the RX was bad the 3-in-1...

That is possible. If the RX was bad the 3-in-1 would behave like that.

What does the RX do when you plug the bind plug in?
08-07-2009, 03:41 AM
Replies: 13
Views: 2,065
Posted By Twmaster

It's not likely a burned ESC. First, the CX3 has...

It's not likely a burned ESC. First, the CX3 has PTC fuses on the motors. Second, It's not arming. This is a throttle detect error. As Smoke suggested make sure the throttle and trim is all the way...
08-03-2009, 04:55 PM
Replies: 4
Views: 1,537
Posted By Twmaster

It's not hard on that heli. Setting up any...

It's not hard on that heli.

Setting up any heli requires you to be careful though. For example leveling the swash plate to the three cyclic servos is very important.

Best of luck Sam!
08-02-2009, 12:13 AM
Replies: 1
Views: 726
Posted By Twmaster

You can use them to double up in the plane. While...

You can use them to double up in the plane. While you can also charge with that you would not be able to balance the packs while charging unless you have separate balancers.

Other than that I...
07-30-2009, 04:38 PM
Replies: 25
Views: 12,367
Posted By Twmaster

AMA.... When we say two or three cells we...

AMA....

When we say two or three cells we mean Lithium Polymer batteries.
07-30-2009, 04:46 AM
Replies: 25
Views: 12,367
Posted By Twmaster

That is a beauty of an old plane. The 1/2A...

That is a beauty of an old plane.

The 1/2A sized planes work really well with what we call 'speed 400' sized motors. A decent outrunner with about 80 to 100W of power would really pull the old...
07-27-2009, 08:34 PM
Replies: 11
Views: 2,840
Posted By Twmaster

Before you go and spend any more money go back to...

Before you go and spend any more money go back to step 1.

Make sure everything is connected correctly. Make sure the crystals are seated fully and you've put the TX and RX crystals in the correct...
Replies: 21
Views: 1,849
Posted By Twmaster

Ok all this back and forth has driven me nuts. I...

Ok all this back and forth has driven me nuts. I just went and looked.

My EC135 has separate rudder/throttle leads. Both with 3 wires. My MD500 has leads like your EC135 and the solitary white...
Forum: Power Systems
07-25-2009, 07:16 PM
Replies: 2
Views: 819
Posted By Twmaster

Unfortunately unless you are capable of...

Unfortunately unless you are capable of re-drilling, re-tapping and putting new screws into this it sounds like you need to return it.

That is the downside to cheap motors.
07-24-2009, 06:41 AM
Replies: 11
Views: 2,840
Posted By Twmaster

Happy to help. Welcome to WattFlyer. We are glad...

Happy to help. Welcome to WattFlyer. We are glad you are here.

In the short term you'll likely be ok. However do put that antenna on as soon as you can.

Good luck!
07-24-2009, 04:44 AM
Replies: 11
Views: 2,840
Posted By Twmaster

Go to the E-Flite web site and download the...

Go to the E-Flite web site and download the manual for the original Blade-CP. It will have a diagram showing correct installation and connections to the unit.

As to that TX antenna you need to fix...
Replies: 15
Views: 4,918
Posted By Twmaster

Also, two additional points... I am not...

Also, two additional points...

I am not bashing 2.4GHz. There are good radio sets on that band and to some the 'comfort' of not worrying about shoot downs is a good thing.

Second, when I am...
Replies: 15
Views: 4,918
Posted By Twmaster

If I only had two or three planes then I would...

If I only had two or three planes then I would have kept the X9303 (Magnificent radio BTW) and just sucked it in and bought a couple AR7000 receivers.

I have close to 10 aircraft either flight...
Showing results 1 to 30 of 158
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.07057 seconds with 7 queries