WattFlyer RC Electric Flight Forums - Discuss radio control eflight - Search Results

Search: Posts Made By: omster
Showing results 1 to 5 of 5
Search took 0.00 seconds.
Forum: ParkFlyers
04-21-2017, 04:15 PM
Replies: 160
Views: 65,757
Posted By omster

Okay, thanks - not going to use the new 18A...

Okay, thanks - not going to use the new 18A ESC... will swap out with a Castle Phoenix 25A.

Still trying to figure out placement of electronics and Rx. Do most people run servo extensions on the...
Forum: ParkFlyers
04-16-2017, 02:30 AM
Replies: 160
Views: 65,757
Posted By omster

Thanks for your guidance - my Emax 2812 came in...

Thanks for your guidance - my Emax 2812 came in today, 7x6 props yesterday :) I have a new 18A esc I was planning on using, hopefully that'll be okay?

Not sure on the FPV gear weight... will be...
Forum: ParkFlyers
04-12-2017, 11:43 PM
Replies: 160
Views: 65,757
Posted By omster

I have a couple of these motors - it's a higher...

I have a couple of these motors - it's a higher kV rating, how do you think it would do with their suggested props?
http://graysonhobby.com/supersonic-2212-06-v2-30amp-esc-brushless-combo-basic.html
Forum: ParkFlyers
04-12-2017, 09:09 PM
Replies: 160
Views: 65,757
Posted By omster

quorneng - thanks for your response! I...

quorneng - thanks for your response!

I attached a picture of the body and landing gear - is it a Wing Dragon?

Okay, will definitely glue the wing halves together along with the wood spar! My...
Forum: ParkFlyers
04-12-2017, 02:41 AM
Replies: 160
Views: 65,757
Posted By omster

Just got an old Wing Dragon from my bro - well,...

Just got an old Wing Dragon from my bro - well, at least I think it's a Wing Dragon, there's no instructions and the stickers don't match any that I've seen :confused: Also, the body and wings are...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.04944 seconds with 7 queries