WattFlyer RC Electric Flight Forums - Discuss radio control eflight - Search Results

Search: Posts Made By: Davjed
Showing results 1 to 14 of 14
Search took 0.00 seconds.
Replies: 6
Views: 768
Posted By Davjed

Big Thanks To Andy....

Andy, thank you SO MUCH for giving me the directions to unlock the low voltage alarm on my Dx6e radio. You've saved me the cost of returning it, having it unlocked, and returned, not to mention the...
Replies: 6
Views: 768
Posted By Davjed

Thanks for the reply, Birddog. I already have...

Thanks for the reply, Birddog. I already have talked to them and they suggested sending it in. I was hoping that one of the gurus on here would suggest something short of that.
Replies: 6
Views: 768
Posted By Davjed

Unhappy Low voltage warning problem.....

HELP! Somehow I got the low voltage warning buzzer set too high on an almost new Spektrum Dx6e. The warning activitates seconds after it is turned on, way to fast for me to be able access and reset...
04-10-2017, 06:13 AM
Replies: 2
Views: 751
Posted By Davjed

Angry I know your pain.........

Darned older battery run drills with dead batteries that cost as much as a new drill to replace!:mad: Been tempted myself lately. :rolleyes:
03-13-2017, 06:06 AM
Replies: 4
Views: 407
Posted By Davjed

Ah, the sounds of my childhood living close to...

Ah, the sounds of my childhood living close to several training bases. They were in the air all day and night.
10-31-2016, 06:17 AM
Replies: 5
Views: 1,026
Posted By Davjed

That's the one used in the HZ Sport Cub and is...

That's the one used in the HZ Sport Cub and is 3.7v. WLtoys has one, 949 I think, that's 3 channel and only @ $15 from China on ebay.
08-14-2016, 08:56 PM
Replies: 48
Views: 19,789
Posted By Davjed

OK, so no one knows about fixing boards, has...

OK, so no one knows about fixing boards, has anyone tried replacing this $60 board with a cheaper one from another manufacturer. I've seen a couple in the $15-$20 range that might work. Any...
Replies: 6
Views: 1,197
Posted By Davjed

Thanks

For the advice above guys. It worked!! I went outside and went 25 to 30 feet down the driveway and presto, it connected. I circled the back yard with it then put it away until I can go to the park...
Replies: 6
Views: 1,197
Posted By Davjed

Failure to bind

I have a HZ Champ that will not bind either with the tx that came with it or a Dx6i. The red led blinks fast when it's powered on but will not bind and go constant. Any suggestions or ideas to get it...
Replies: 9
Views: 1,303
Posted By Davjed

PROBLEM SOLVED: HZ suggested checking the monitor...

PROBLEM SOLVED: HZ suggested checking the monitor screen for excessive signal to that channel. I did so an it showed an elevated input to that one channel. I then checked three other planes stored in...
Replies: 9
Views: 1,303
Posted By Davjed

Spektrum Dx6i. HZ says it may be a defective...

Spektrum Dx6i. HZ says it may be a defective gimbal in the transmitter that needs to be returned for repair. However, I have other planes programmed into it that don't have this problem.
Replies: 9
Views: 1,303
Posted By Davjed

Servo or receiver problem?

Setting up a newly built kit and having a problem with the elevator servo. Using a servo tester/centering device I centered the Tower Pro servo and attached the arm. However, on installing the servo...
07-29-2016, 09:37 PM
Replies: 1
Wanted I need......
Views: 1,287
Posted By Davjed

I need......

A back cover for a FlySky FS-CT6B transmitter. I left it recharging lipo batteries in my 12v vehicle outlet too long. It ruined the batteries and melted the back cover of the unit. It still works...
07-25-2016, 02:36 AM
Replies: 48
Views: 19,789
Posted By Davjed

Sport cub s board repair

Anyone here familiar with repairing motherboards in this little kitten? I have one that won't bind. When powered up, then red led flashes slowly like it is ready to bind but it will not recognize my...
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.05147 seconds with 7 queries