View Single Post
Old 06-25-2014, 12:12 AM   #2
Join Date: Dec 2013
Location: OBX Kill Devil Hills, NC
Posts: 353
Thanked 23 Times in 23 Posts
Club: Dare County RC Flyers
iTrader: (0)
Friends: (2)
Default QB 10H cont.

Next up the wings. This is a major deviation from the plan since I had my new and improved hot wire cutter going - so I cut foam cores and sheeted them with 1/16" balsa glued on with WEST epoxy resin and squished down in my wing press which is a pair of sturdy Melamine boards with 14 carriage bolts and wing nuts doing the squeeze thing. The dihedral was just butt glued and covered with 1 1/2 oz glass. Peel ply squished down on wet glass lam saves a ton of sanding = none required.

Attached Thumbnails
Click image for larger version

Name:	QB 10H 003.jpg
Views:	97
Size:	104.7 KB
ID:	176231   Click image for larger version

Name:	QB 10H 013.jpg
Views:	69
Size:	91.2 KB
ID:	176232  
carpetbagger is offline  
  Reply With Quote
Page generated in 0.04867 seconds with 19 queries