View Single Post
Old 11-20-2009, 08:40 AM
  #1  
jedorme
Member
 
Join Date: Aug 2009
Posts: 21
Default JR Transmitter Problem

I'm setting up a JR 6 channel tx in a new Sig Kadet Seniorita with a 6 channel Hitec rx. Using servo leads on chan 2 & 6 to my aileron servos, the left aileron (chan 6) goes to full up or down, depending on how flap switch is positioned, & can't be controlled with aileron stick. How do I get it to go from a flap to an aileron? I can zero it out with the travel adjustment but still no response to aileron stick. Also how do I get both ailerons to work as flaperonswhich the manual says you use travel adjust & dual rate settings to do, but doesn't explain how? I hooked up a Y cord until I could get this 2 channel aileron setup to work, & airplane flies fine that way. But I would like the benefits of individual control, including flaperons. The Sig floats forever if no wind to land against! Thanks for any help.
jedorme is offline  
 
Page generated in 0.06679 seconds with 7 queries