View Single Post
Old 12-23-2009, 02:11 PM
PaperAirplane's Avatar
Join Date: Aug 2009
Location: USA
Posts: 849

Originally Posted by philipa_240sx View Post
If you force a servo hard enough you can strip the gears.

Personally, I would disconnect the linkage, remove the servo's from the plane and test them. You can simply rest them on a table top or something. If they still behave erratically then I would start looking at your connections, the RX and perhaps try a different servo.
Ok, will try that. I dont have more servos, so I may have to order another.
PaperAirplane is offline  
Page generated in 0.05612 seconds with 7 queries