Old 06-24-2011, 05:30 PM
  #137  
Slow & Low
b1heqh54
 
Slow & Low's Avatar
 
Join Date: Mar 2008
Posts: 196
Default

This is very light cloth. Mostly it's scraps of 1/2 and 3/4 oz/^yd
that I've set aside when covering other models in the past. I haven't laid any epoxy on it yet, just put it down on the tacky surface coat.

This is what you won't see a lot of others doing: they should.
I've placed it into all of the tight corners. What you do not want are air bubbles and voids. A heavier cloth will show through the tool coat over time and the surface veil will not stay in the tight corners.

Slow & Low is offline  
 
Page generated in 0.06550 seconds with 8 queries