View Single Post
Old 08-24-2008, 05:54 PM
  #193  
radweld
Member
 
radweld's Avatar
 
Join Date: Jun 2008
Location: High Wycombe, Bucks, UK
Posts: 190
Default

Originally Posted by joeted View Post
Is it really ? Ive actually put the motor mount above the stock gear box holes so it should be higher than the stock lol.Does it look to low down to effect it ?
Actually forget what I said, it looks like it's fine. I just re-checked what I did and it looks to be in the same position.



As for Prop, I think a 10x7 should be ok but BRC always provide a datasheet with the motor to help you decide what prop to use, if you didnt get it give them a call.
radweld is offline  
 
Page generated in 0.04446 seconds with 8 queries