WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Zlin-50 "MAZDA"
Thread: Zlin-50 "MAZDA"
View Single Post
Old 03-08-2009, 05:25 AM
  #5  
ezra
New Member
 
Join Date: Feb 2009
Posts: 9
Default NitroPlanes experience

I don't have that plane but I can speak on my experience buying a piper cub from Nitro Planes...

Price - as you probably know they are very reasonably priced

Quality - Overall the construction was good except for minor issues with the heat shrink covering. The wing had ripples in it, that I had to fix with a hot iron and the colored pattern stuck to the outside of the covering was pealing off a little.

Instructions - Horrible; the instructions I got were worthless, you basically had to figure it out on your own. The plane was different than the instructions in several areas.

Overall; I think they are OK. They are made in China. I would buy one again if they had a plane I wanted but I may look around a bit to see if I could find a bit more quality in the covering and manual for not to much more money.
ezra is offline  
 
Page generated in 0.03104 seconds with 10 queries