WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Fixing connectors to the motor help
View Single Post
Old 09-30-2011, 08:47 PM
  #13  
kyleservicetech
Super Contributor
 
kyleservicetech's Avatar
 
Join Date: Apr 2008
Location: Wisconsin, USA
Posts: 8,952
Default

Originally Posted by Glacier Girl View Post
Just in case, to further Dennis' tip on the wire nuts. In case you may have missed the point. Snip the leads off the old motor, strip a small section of insulation off of each. Then use the wire nuts to connect them to your new motor's leads.
FYI, a few motors use the actual magnet wire itself as the lead out wire for the motor. Motors such as the Hacker line use many strands of this stuff. Problem is, this magnet wire is coated with a very thin very difficult to remove coating of varnish.

So, if you've got a motor like this, would be best to unsolder the connector first, and then solder the new connector to the motor leads.
kyleservicetech is offline  
 
Page generated in 0.02915 seconds with 8 queries