Old 12-01-2013, 04:01 PM
  #1  
kittiwat1
New Member
 
Join Date: Dec 2012
Posts: 4
Default Not getting 4.2 volt per cell count with PL 8

Hi,
I dont know if there is an issue with my PL8. I charge four 6 cells 5000 mAh Lipo packs with a parallel board. When charging is done (alarm sounds), when I measure voltage of each cell of all the batteries some show 4.21, 4.14, 4.19, 4.19, 4.18 etc. I was hoping to get all cells being close to 4.2 v but the gap between each is wider than I would like it to be. Note that all batteries' voltage at the start do not diffier more than 0.2 volts. Is this normal?
kittiwat1 is offline  
 
Page generated in 0.03196 seconds with 9 queries