Old 04-14-2022, 11:42 AM
  #9  
peterb_2795
New Member
 
Join Date: Apr 2022
Posts: 2
Default

Hi,
I realise that this is a quite old thread but am just wondering if you had full success in converting your JR X9503 from mode 2 to mode 1. The reason that I ask this is that I have recently acquired a 'brand new' condition mode 2 X9503 and also need to convert it to mode 1.

I have seen a few threads on X9303 conversion and mention of required access to the Service Menu. I haven't found anything on being able to access the Service menu. I am quite handy with a soldering iron and small component/joint soldering and certainly not a goose at taking things apart and putting them back together.

Given that you have been through this process, any advice and info that you have available would be very much appreciated.

Cheers,
Peter
peterb_2795 is offline  
 
Page generated in 0.06874 seconds with 8 queries