WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - $50.00 Scratch Build Contest Entry, F-20 Tigershark
Old 09-12-2013, 04:50 PM
  #17  
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 19,246
Default

Originally Posted by quorneng View Post
Chellie
That's quite a bit of Depron bending! It looks very nice

I have laminated 2 or more layers of thin 2mm Depron to get a sharp curve using PVA as the glue. It has to held firmly in place and takes 24 hrs to dry but the end result is almost like moulded 3 ply.

However my preferred method is 'planking' over formers mainly because individually fixing each plank puts very little load on the structure.
Thank You I will be using 2mm depron for the air Ducts, I know that will be Easier to bend I used a can and taped and heated the depron foam rear part of the fuselage to get a rounded form, Its getting there, Take care, Chellie
CHELLIE is offline  
 
Page generated in 0.02681 seconds with 7 queries