WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - $50.00 Scratch Build Contest Entry, F-20 Tigershark
Old 09-14-2013, 05:48 AM
  #24  
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 19,246
Default

Originally Posted by pmullen503 View Post
If you can find a can the right size, cover the outside of your foam with packing tape, tape it to the can and fill the can with boiling water. That happens to be the perfect temperature to mold foam. You may have to add the boiling water twice for thick foam.

Even if the can is a little over-sized, it puts a nice curve in the foam that can be used to make a cylinder that's the correct size. Very useful for foam cowls, turtle decks, and EDF thrust tubes.
Thank You great Idea, I will Remember that in the future for sure

Originally Posted by quorneng View Post
Chellie
I have just been reading up on the Tiger Shark. What a sad story but it does rather demonstrate that foreign countries will only buy what the USA actually uses!
I Know, Politics Killed the F-20, it was one great plane, Quick to Respond, cheap to maintain, for its time, it was a sweet bird
CHELLIE is offline  
 
Page generated in 0.04472 seconds with 8 queries