WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Help Need build sheet instructions
View Single Post
Old 01-07-2017, 09:35 PM
  #41  
grumpyscm
New Member
 
Join Date: Jun 2013
Location: Clarkesville GA
Posts: 0
Default

Originally Posted by grumpyscm View Post
Looks OK If You are going to use a spinner you will have to adjust for the spinner backing plate and if not you will have to adjust for prop clearance. Either move the motor forward or work with the cowl, which ever is easiest. I suggest about 1/16 inch clearance. Try not to have to use any spacers on the prop adapter. and be sure your prop is balanced. Using spacers opens you up to vibration problems.
It also looks as if you will have plenty of incoming air for the motor cooling but you will have to provide for the air to exit also. It is also a possibility that you can mount your ESC to the motor mount box in the same air stream that comes off the motor. As a suggestion you want the exit area approximately 1/3 larger that the entrance area.
grumpyscm is offline  
 
Page generated in 0.04755 seconds with 8 queries