WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Help Need build sheet instructions
View Single Post
Old 01-07-2017, 09:46 PM
birdDog's Avatar
Join Date: Nov 2007
Location: Too close to Chicago.
Posts: 2,433

The cross hairs burned into the firewall, they project to the center of the motor shaft at cowl length from the built in right thrust angle. Your motor mounting should be centered on them. As currently built, your cowl is skewed to the right.

Also, it is good practice to go over all accessible glue joints with thin CA (superglue). Some occasionally get missed in production and it's nice to personally verify that all main structural elements are secured.
birdDog is offline  
Page generated in 0.05183 seconds with 10 queries