WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Help Need build sheet instructions
View Single Post
Old 01-07-2017, 11:24 PM
New Member
Join Date: Nov 2016
Posts: 18

Originally Posted by birdDog View Post
The cross hairs burned into the firewall, they project to the center of the motor shaft at cowl length from the built in right thrust angle. Your motor mounting should be centered on them. As currently built, your cowl is skewed to the right.

Also, it is good practice to go over all accessible glue joints with thin CA (superglue). Some occasionally get missed in production and it's nice to personally verify that all main structural elements are secured.
Your saying I should center the motor on the cross hairs on the motor mount, not center it on the center of the box like I did? Why is that important?

There is an area on the bottom of the fuselage that I can cut out the laminate for air movement through the plane.

Spike101 is offline  
Page generated in 0.03121 seconds with 8 queries