Thread: Trim Tabs
View Single Post
Old 05-20-2011, 01:44 AM
  #6  
flypaper 2
Super Contributor
 
flypaper 2's Avatar
 
Join Date: Jul 2005
Location: Kingston Ont. Can.
Posts: 1,237
Default

Just for an experiment, I put these servo tabs on my old beater Corby Starlett. I had to be careful how much throw they have, as if you overdrive it, it will force the surface hard to the end. I went one hole at a time, test flying it at each one till finally the roll rate went way up like I put the next size bigger servo in it. After researching them, I found the tab had to be no bigger than 10% of the area of the control surface. Also said it took about 75% of the load off the servo.
Attached Thumbnails Click image for larger version

Name:	18040749.JPG
Views:	741
Size:	69.1 KB
ID:	148501  

Last edited by flypaper 2; 05-20-2011 at 03:11 AM.
flypaper 2 is offline  
 
Page generated in 0.04505 seconds with 10 queries