View Single Post
Old 08-31-2013, 05:32 PM
  #1  
Fritzngertie
Member
 
Join Date: Jul 2009
Location: Valrico, FL
Posts: 30
Default T-28 ParkZone ESC/Motor

I crashed my T-28 plane. I was flying straight and level when the plane started to act as if I was moving the rudder, elevator and aerliron in both directions rapidly and all at the same time. I could not control it and it crashed into the ground. Is it possible that the esc or motor could have overheated. I normally fly two aircraft alternating between them. This time, I didn't, I was on my second flight. The plane was out far enough that I could not hear the motor. I live in Florida and so there is plenty of heat. Also, with the cowling around the motor and esc I don't think much air flow gets in. Any comments would be welcome. This has happened to me before and I replaced the esc because it crashed into a small pond.

Thanks,

Don

Last edited by Fritzngertie; 08-31-2013 at 07:37 PM.
Fritzngertie is offline  
 
Page generated in 0.07913 seconds with 9 queries