View Single Post
Old 11-18-2008, 02:04 PM
Club RAGE Member
Join Date: Jun 2007
Location: Broken Arrow, OK
Posts: 85

Originally Posted by gfdengine204 View Post

Looks real nice. How did you support/build in the dihedral, and how did you get such nice checkers for the rudder?

The dihedral is not complete yet in these pictures. When glueing the halves together I laid one wing flat and supported the other 1-3/4" off the table and epoxied them together. I plan on taping a braces to the bottom sides of the wing then come through the wing from the top with a brace that will tie the two together at the vert fuse. I will probably use string and epoxy at the joints, it's a work in progress (ie. I'll have to figure it out as I go).

The checkers are my son's doing. He went with a 3/4" spacing and colored them with Sharpies.

gregore2992 is offline  
Page generated in 0.04235 seconds with 8 queries