WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Capricorn - the ultimate flying boat.
View Single Post
Old 12-11-2007, 11:43 AM
  #106  
leadfeather
Member
 
Join Date: Mar 2007
Posts: 70
Default

The 1/2" stuff is nice to work with. Just as flat as depron, sands pretty easily, and it is cheap. Still thin enough cut with a utility knife. It is also thick enough to flush mount servos.

The biggest plane I've built with this stuff was a 40" span delta. It didn't need any reinforcing except strapping tape spar caps top and bottom.

I think I'm going to give it a try on the center wing panels on my Capricorn.

The Cap isn't the sexiest looking hydro, but it sure seems to be the best flying hydro .
leadfeather is offline  
 
Page generated in 0.04623 seconds with 8 queries