View Single Post
Old 12-23-2009, 11:32 AM
  #112  
philipa_240sx
Super Contributor
 
Join Date: Jul 2009
Location: Ontario, Canada
Posts: 1,046
Default

If you force a servo hard enough you can strip the gears.

Personally, I would disconnect the linkage, remove the servo's from the plane and test them. You can simply rest them on a table top or something. If they still behave erratically then I would start looking at your connections, the RX and perhaps try a different servo.
philipa_240sx is offline  
 
Page generated in 0.06169 seconds with 10 queries