WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - How to remove landing from retract body
View Single Post
Old 08-11-2018, 04:19 AM
  #2  
solentlife
Super Contributor
 
solentlife's Avatar
 
Join Date: Oct 2010
Location: Ex UK Brit now in Latvia west coast - Ventspils
Posts: 12,408
Default

Most retracts have grub screws into the sides of the trunnion (the bit that rotates). To get at them - you need to remove the whole gear from its mount so you have access to both sides ...
With most - you will see a brass insert in each side ... its the pivot ... a 1.5mm hex driver inserted in will find the grub screw deep inside. You do not have to unscrew and remove ... but unscrew enough to clear the flat on the landing leg.

Nigel
solentlife is offline  
 
Page generated in 0.04551 seconds with 8 queries