WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - How to remove landing from retract body
View Single Post
Old 08-11-2018, 04:26 PM
  #3  
Jack_K
Member
 
Jack_K's Avatar
 
Join Date: Apr 2015
Location: Ft Worth, TX
Posts: 40
Default

Originally Posted by solentlife View Post
Most retracts have grub screws into the sides of the trunnion (the bit that rotates). To get at them - you need to remove the whole gear from its mount so you have access to both sides ...
With most - you will see a brass insert in each side ... its the pivot ... a 1.5mm hex driver inserted in will find the grub screw deep inside. You do not have to unscrew and remove ... but unscrew enough to clear the flat on the landing leg.

Nigel

Thanks Nigel. That clearly explains it.
Jack
Jack_K is offline  
 
Page generated in 0.02887 seconds with 10 queries