WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Free Flight to RC Conversion
View Single Post
Old 01-08-2020, 11:47 PM
  #7  
quorneng
Super Contributor
 
quorneng's Avatar
 
Join Date: Jul 2008
Location: Cheshire, UK
Posts: 1,890
Default

foxch0844
Chellie's recommendation look good.
The Berkley Fairchild 24 has a light weight construction (5.8 oz complete incl the rubber motor!) so it is best to keep the weight as an electric RC conversion as low as possible.
I also note Jet planes Flyer's earlier recommendation to avoid using normal heat shrink film. The original structure was intended to to tissue covered. Modern heat shrink films pull very tight so can over load the light weight structure and are significantly heavier than tissue.
Are you sure it will need ailerons? As a high wing with adequate dihedral it will manage fine on just rudder, elevator and throttle (RET). This will save both mods to the wing and some weight.
quorneng is offline  
 
Page generated in 0.03027 seconds with 10 queries