WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - XXL Polaris scratch build
View Single Post
Old 07-01-2009, 03:15 AM
  #177  
CHELLIE
Super Contributor
 
CHELLIE's Avatar
 
Join Date: Oct 2006
Location: Hesperia, So. Calif
Posts: 19,246
Default

Originally Posted by Fviking View Post
My Polaris is done, and the wind is kicking up whitecaps on the lake !
I waterproofed my ESC with conformal epoxy 3M makes it it is called DP 270
you mix it up and after removing the shrink wrap pour it all over in into the ESC, not on the heat sink though. Then take a heat gun and heat it up the epoxy thins out and most runs off but enough to waterproof it remains. Hang it over a paper plate untill it stops dripping.
You can find 3M DP 270 and Corrosion X Here http://www.offshoreelectrics.com/products.php?cat=79
I also do Fast Electric Boats that is where I learned that trick. I have a 36" fiberglass boat I made that does 50 mph. Video here [media]http://www.youtube.com/watch?v=b5l_dtsMtSs[/media]Enjoy;
John
Nice Boat John it seems to bounce to much on the water, would plastic flexable trim tabs here, to help keep the nose down Take care and have fun, Chellie
CHELLIE is offline  
 
Page generated in 0.02742 seconds with 8 queries