View Single Post
Old 08-14-2016, 05:10 PM
  #19  
rcpilot134
Member
 
rcpilot134's Avatar
 
Join Date: Jun 2016
Location: NJ
Posts: 104
Default

I know this is an old thread but yes this is a very good in depth explanation of the process to go through to set up gains on any particular model. Thank you.

I saw something that I was not aware and explains something I observed on a 7350 RX. No place to set DR and Expo which is fine by me. Prefer to do it TX side as it is alot easier to check your settings on the TX than connecting to a laptop or a phone compatible with the software - same goes for making changes. Or at the very least, make DR and Expo that is set on the RX viewable on the TX. I don't think that's an option or at least I can't figure out how.

I also saw in one of the posts here that they plan on transferring DR and Expo functions back to the TX in firmware updates for the 636 - anyone know when that's going to happen?
rcpilot134 is offline  
 
Page generated in 0.05049 seconds with 7 queries