Old 03-19-2010, 02:16 AM
  #70  
Ianh
New Member
 
Join Date: Mar 2010
Posts: 2
Default Two for One

I have been reading this forum with keen interest as I am learning to fly with one of these planes. I too had the same problem with the control rods being too short. However, after I had an inevitable crash, I hit upon this solution. The two screws securing the boom seemed to me way too flimsy, and after the crash one was toast, so I removed the screws and replaced with a 9.5-12mm clamp from our local harware store. Not only does it hold the boom better, thus avoiding twisting, it also means you can move the boom further in, to fix the control rod length problem. Have tested it and it flys fine.



Ianh is offline  
 
Page generated in 0.04299 seconds with 8 queries