WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Flew my first Stryker today. Am I late?
View Single Post
Old 03-20-2017, 01:49 AM
  #7  
Gregco10
New Member
 
Join Date: Jan 2017
Posts: 3
Default

I never had good luck with that receiver. I would put it in a good spot, away from the battery for one thing. Antennas should be clear of things and in the open if possible. On my old multirotors I had 2 dropout and crash incidents with these, I mounted them on the bottom most part of the frame that would get good access to the transmitters signal. Then no more problems after that. Also make sure the transmitter voltage is adequate.

As far as the motor goes I dont know what mine actually is since it wasnt mine to begin with and there is no label. I think the stock motor was 1800kv and a 2860 ish. Inrunner. I think a 70 gram 1800kv outrunner with a 6x5.5 apc e would work good. That was my backup if what was in there didnt work.
Gregco10 is offline  
 
Page generated in 0.05189 seconds with 10 queries