WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Blade CX for those to talk about
View Single Post
Old 12-03-2005, 11:27 PM
  #21  
Tonym
Member
 
Join Date: Nov 2005
Posts: 26
Default

I got my CX in from Will's Hobbies. Thanks guys!

It fly's nice. I'm having a couple of problems with it that I'm sure must just need to be trimmed out. It rotates while hovering even with the trim on the TX set all the way to the right, so I just need to adjust the proportional mix.

The other thing that I noticed about it, and I didn't notice this before, the blades are fixed rigid. That is to say they don't fold at all like all of the other heli's I've seen. This means that if the blades strike something they won't give and the main shaft and rotor head will take the full brunt of the impact. The blades are hard plastic so I doubt they will break before the little pins on the rotor heads.
Tonym is offline  
 
Page generated in 0.04809 seconds with 8 queries