WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Choosing an electric power system for your model
Old 01-13-2008, 05:55 AM
  #13  
AEAJR
Community Moderator
 
Join Date: Aug 2005
Location: NY, USA
Posts: 5,827
Default

The plane weighs a little over 2 pounds. If you read the article you know we can target several levels of performance.

So we want at least 120 watts and I would target 150 watts.

To draw 150 watts on a 7 volt pack we would need a pack that can handle 21 amps and a prop that will cause the motor to draw about 21 amps.

That is about the top of what a Speed 600 can handle.

While your 6 cell 3700 battery can probably deliver 21 amps, 6 cells probably can't turn the moto fast enough and the prop won't load it up enough.

I would recommend you go to at least a 7 cell pack and 8 would be better.

I presume that pack is Sub C cells and an 8 cell pack is going to be heavy.

I would go with 8 cell A size cells or 4/5A that can put out 20 amps.

An 8 cell pack of the ELITE2000 found here would be a good candidate:
http://www.cheapbatterypacks.com/?si...ells&chem=NIMH

The pack would weight about 280 grams, or about 100 grams less than your present pack.

That would be the pack I would recommend. It should give you about 6 minutes of run time. Figure 1 minute for the first climb then 5 30 second climbs after that, leaving you some margin for landing.

And the plane gets 100 grams lighter, about 4 ounces.

More power, less weight. Should work!

Make sure your ESC can handle an 8 cell pack and that he BEC can handle your servos on an 8 cell pack.

Good luck.
AEAJR is offline  
 
Page generated in 0.02995 seconds with 8 queries