WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Build Thread for Rhythm 3D Bipe
View Single Post
Old 05-26-2008, 11:13 PM
  #55  
pstrdenver
Member
 
pstrdenver's Avatar
 
Join Date: Sep 2007
Location: Osceola, IN
Posts: 521
Default

Aero, sorry I haven't been able to post the pics you requested. I will get to them soon. I am away from my things right now.

It sounds like shotgun and I have our electronics in exactly the same place.

My esc battery connector comes up through the space behind the firewall and connects to the battery that is a few inches back towards the tail. The receiver is below the battery one level velcroed to the side. I used velcro on all my pieces but it was a little tricky to get them in place.

Concerning the rounded piece of foam on the nose...when installing the esc I found I needed to cut some of this away. (The rounded part) but left the rest for the support that was mentioned above in shotguns post.

Does this help? Again, I'll post those pics ASAP.

Aero, thanks again for the camera tip.
pstrdenver is offline  
 
Page generated in 0.04705 seconds with 8 queries