View Single Post
Old 07-21-2008, 09:01 AM
  #7  
Lymph
Member
 
Join Date: Jan 2008
Posts: 108
Default

Rudder ATV (aka End Point, Travel Adjust) values?
=======================================
On a non-heading hold gyro this function in your radio is used to set how far the rudder linkage will travel.
On heading hold gyros this function works completely different. It is used to set the maximum rotation rate. So what do you do about limiting the travel so as not to allow the servo to bind? Some gyros have a limit adjustment on them that you use to set this. The ones that do not require you to move the ball on the servo arm further or closer to the center of the arm to limit the travel.
Ugh, more confusing information, think I'll wait and see if anyone responds before I wreck my brain anymore...
Lymph is offline  
 
Page generated in 0.05211 seconds with 8 queries