View Single Post
Old 07-22-2008, 01:45 AM
  #9  
Lymph
Member
 
Join Date: Jan 2008
Posts: 108
Default

Ok, So I found out you can't set end points in HH mode with the stock gyro.

So I put the ball in the 2nd hole from centre on the tail servo horn and the travel was within 1mm of its limits on the tail slider, not perfect but a lot better then binding the servo.

Now in rate mode the travel is a lot less, unless I put the travel adjustment up to about 125% left and right.

I need to know if thats ok. I think it will be since it should only effect the piro speed in rate mode which I won't be flying in.

Or should I simply set it back to 90% as per factory settings and set the tail up so it hovers in rate mode with no drifting and no trim which then sets it up ready to fly in HH mode. Which is what I've read is the correct way to go about it.

Mat.
Lymph is offline  
 
Page generated in 0.05237 seconds with 8 queries