View Single Post
Old 10-08-2020, 05:56 PM
Super Contributor
solentlife's Avatar
Join Date: Oct 2010
Location: Ex UK Brit now in Latvia west coast - Ventspils
Posts: 12,856

Basically unless you have a model with permanent installed battery - there is no need for Rx switch.
If you did install a Rx switch - then a normal RC Rx switch is more than enough as its only cutting the 5 - 6V low power Rx supply and has nothing to do with the high power motor supply. But I suggest its not a good idea to have power to ESC / motor and Rx cut out ...

Better idea is to use the Throttle Cut switch on your Tx.
solentlife is offline  
Page generated in 0.05310 seconds with 8 queries