WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - NX-3 gyro calibration
View Single Post
Old 12-28-2019, 04:34 PM
  #4  
sportflyer
Member
 
Join Date: Sep 2006
Posts: 113
Default

Originally Posted by solentlife View Post
Yes I read that topic but it still does not answer my first question : When after power up do I do the center point calibration . Immediately , anytime after power up? Normally there is a window of time after power up to do it.
1 sec after connecting LIPO is not doable. So my interpretation is that the 1 sec refers to the actual switching time between Rate and HH ie do it very quickly!

The OP is not quite correct in stating that the gyro mode switch cannot be programmed. In my TX I can program the 3 positionn switch by setting the servo position . so I set it to be p1 =0 , p2= -100 , p3= +100 . Now I get OFF, Rate , HH . I guess it depends on the the TX . If you can program a curve then it can be done , otherwise no.

Does any one know who the manufacturer of this NX-3 gyro is? Maybe they can clarify their instructions.
sportflyer is offline  
 
Page generated in 0.04666 seconds with 10 queries