WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - NX-3 gyro calibration
View Single Post
Old 12-28-2019, 11:22 PM
  #6  
sportflyer
Member
 
Join Date: Sep 2006
Posts: 113
Default

After some experimentation I found the following:

To set initial attitude , Turn on TX with mode switch in Rate position. Connect the Lipo and within a few seconds flip the mode switch from rate to HH 2X (rate/HH/rate/HH /rate) quickly . wait a few until servo twitches . Calib done.
I assume that after any trim adjustments during flight , then the mode switch has to be flipped 3X ( just for remembering the trim settings , not attitude setup) and there is no need to level the plane. This is a bit similar to the Eagle tree guardian Gyro where there are 2 calibrations, one for attitude setting , the other for trim adjustments.
sportflyer is offline  
 
Page generated in 0.02984 seconds with 10 queries