Old 12-05-2011, 01:16 AM
  #8  
earthsciteach
Member
 
Join Date: Apr 2011
Location: Dallastown, PA
Posts: 958
Default

Looking at the control surfaces alone, discounting the programming of the tx, it is a good policy to set the control rods on the outermost hole of the control horn. This will limit the amount of surface travel while allowing the plane to be very flyable.

To minimize throw using the control rod: Control rod on innermost hole of servo arm and outermost hole of control horn.

To maximize throw using the control rod: Control rod on outermost hole of servo arm and innermost hole of control horn.
earthsciteach is offline  
 
Page generated in 0.06749 seconds with 8 queries