View Single Post
Old 10-01-2008, 03:03 PM
  #25  
bassplayinDude
Member
 
Join Date: May 2007
Posts: 792
Default

Originally Posted by rcproptester View Post
that sounds easy.
Thanks!
I forgot to mention one thing in my earlier post. Once you've bound the heli to your Tx, always power on your Tx and let it work for a few seconds before powering up the heli. This will prevent your heli from going into binding mode again. If it does happen to go into binding mode, just power it down, wait a few seconds and power up again (while leaving the Tx turned on) and you should be good to go.
bassplayinDude is offline  
 
Page generated in 0.04621 seconds with 8 queries