Thread: HV 110?
View Single Post
Old 09-21-2009, 06:38 AM
  #2  
Larry3215
Look out for that tree!!!
 
Larry3215's Avatar
 
Join Date: Mar 2006
Location: Gig Harbor, Wa USA
Posts: 7,061
Default

If you read your user guide it will tell you what the beeps mean

1 beep and flash
Start failure: The motor was jammed or locked.

2 beeps and flashes
Low Voltage Cutoff: Your batteries are likely discharged. Check that batteries are fully charged and that Phoenix detects the proper number of cells at power-up.

3 beeps and flashes
Over-Current: Current draw exceeded the safe capacity of the controller. Reduce current draw by changing to a smaller propeller, different gear combination, or fewer cells.

4 beeps and flashes
Motor Anomaly: Controller encountered abnormal motor behavior such as a prop strike or other physical interference. May also indicate lost synchronization or magnetic overload within the motor.

5 beeps and flashes
Radio Signal: Signal from receiver is corrupt or non-existent. Check transmitter and receiver.
5 beeps/flashes indicates a radio problem which could explain the cut off. The controller will shut down if it looses radio signal. Check your throttle lead. You may have a bad servo extension or something in the plug thats bad etc.

You dont mention which motor your using or how many amps your pulling. It sounds like you may be hitting the low voltage cut off too.
Larry3215 is offline  
 
Page generated in 0.07971 seconds with 8 queries