View Single Post
Old 12-20-2009, 11:13 PM
  #1  
999flyer
New Member
 
Join Date: Aug 2005
Location: Hampshire, UK
Posts: 11
Default CC Phoenix 10 and Axi 2203/46

I have a CC Phoenix 10 (micro2/F330) esc fitted to a Techone Gent epp shockflyer indoor model and have updated to v3.00 using my Castle Link. I am using a new Axi 2203/46 motor with a 8x4.3 GWS prop and new 20c 2s 480mah LiPo's and am not getting as much power as I expected to get.

Can anyone advise if the settings listed below are correct for the Axi 2203/46, particularly timing and PWM settings?

################################################## #####
# Castle Link Data File
# Created: 19 December 2009
# Do Not Edit This File By Hand
################################################## #####
Hex55: 85
Brake Strength: 50
Brake Delay: .6 sec (Delayed) (*)
Brake Ramp: Immediate (*)
Cutoff Type: Soft Cutoff
Motor Start Power: 59
Direction: Forward (*)
PWM Rate: 12 Khz (*)
Vehicle Type: Airplane
Throttle Type: Auto-Calibrate Endpoints
Throttle Response: 8
Governor Gain: 15
Initial Spool-Up Rate: 5
Head Speed Change Rate: 5
Auto Rotate Enabled: False
Governor Mode Type: Simple
Cutoff Voltage: 60
Current Limiting: Insensitive
Motor Timing: 5
Power-On Beep: Enabled (*)
Auto-Lipo Volts/Cell: 3.0 Volts/Cell (*)
999flyer is offline  
 
Page generated in 0.08238 seconds with 9 queries