View Single Post
Old 10-15-2020, 04:29 PM
Super Contributor
solentlife's Avatar
Join Date: Oct 2010
Location: Ex UK Brit now in Latvia west coast - Ventspils
Posts: 12,764

It would have been OK if I had noted down the X Y Z numbers when I paused the print ... at least I would have stood a chance of resuming where it left off.

I know what you mean not there .... my other 3D printer decided to lose its nozzle ...... hot filament went everywhere ....

I stripped it all down ... heated up the parts and peeled what I could off ... then used the non acetone nail polish remover to soften up the PLA I couldn't get to.

Cleaned threads and refitted. Lasted about 10 minutes ... same again.

Bought new head parts ... fitted ... BINGO ... jobs a good'un.

But I certainly do not want to repeat the clean up !!
solentlife is offline  
Page generated in 0.06730 seconds with 8 queries