help! himax and turnigy plush 60a
01-30-2009, 11:26 PM
#1
Member
Thread Starter
Join Date: Aug 2008
Location: West of Ireland
Posts: 64
help! himax and turnigy plush 60a
Folks
Have my multiplex mentor ready to go. Connected my Multiplex Himax 3528-1000 brushless outrunner to my Turnigy plush 60a esc, connected my 3200mah 3s 11.1v lipo. Turned on the tx and rx. Esc went through normal startup sequence of beeps. When I apply throttle motor shudders a few grating rotations and then stops. it doesnt sound healthy. like an old engine trying to start in winter. repeated the process a few times to the same results.
the motor spins fine and freely in my hand when i rotate the prop with the power off.
Your help would be greatly appreciated.
zoom
Have my multiplex mentor ready to go. Connected my Multiplex Himax 3528-1000 brushless outrunner to my Turnigy plush 60a esc, connected my 3200mah 3s 11.1v lipo. Turned on the tx and rx. Esc went through normal startup sequence of beeps. When I apply throttle motor shudders a few grating rotations and then stops. it doesnt sound healthy. like an old engine trying to start in winter. repeated the process a few times to the same results.
the motor spins fine and freely in my hand when i rotate the prop with the power off.
Your help would be greatly appreciated.
zoom
01-31-2009, 12:50 AM
#2
Megans Servant
Join Date: Dec 2006
Location: My Basement
Posts: 2,213
Might start by double checking the solder joints at you bullet connectors. Had something like that on a motor once and when I pulled on one of the wires it came right out of the plug. Resoldered it and no troubles since.
Thread
Thread Starter
Forum
Replies
Last Post
Grasshopper
Motors and Speed Controllers for sale & WTB
0
01-17-2009 05:28 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
