FMA Direct Discuss FMA Direct products or ask your support questions.

Pl6 safety code 96 at low current charge rates

Old 05-10-2014, 03:44 PM
  #1  
Kaborkian
New Member
Thread Starter
 
Join Date: May 2014
Posts: 1
Default Pl6 safety code 96 at low current charge rates

Charger: powerlab 6, ordered at Lhs and purchased about 3 months ago
Power supply: 2xhp server supplies in series, 24.8v, 1100 watts total

Can charge combinations of 3s to 6s without issue, charge rates vary from 5a to 35a.

When charging small batteries, specifically 2s300 x 3 lipo parallel at 2c, or 600ma per pack, 1.8a total, or a 6s1700 NiMH at 2a or less, I get safety code 96 a few minutes into charge. When charging the NiMH, it will sometimes false peak and go to trickle in just a few minutes.

Any ideas?
Kaborkian is offline  
Old 05-12-2014, 03:41 AM
  #2  
Gregor
Member
 
Join Date: Sep 2007
Posts: 65
Default

From the manual for safety code 96

"PWM ratio too high. Check the power supply and output wiring"

I would look closely at all wiring between the charger and the supplies. Ideally the supply uses good quality 10 AWG to an EC5 connector. No adapters and no 4mm bananas.

With server supplies, DC (not AC) ground should removed from only the second supply in series (supply delivering 24v positive). The connections should be solid.

If another supply is available for testing that would be helpful. Alternatively a 12v car battery can be used to for testing.

For the NiMh packs, they may need several slow forming charges. Slow charge and discharges using a low rate. The charge cycle should take about 10 to 15 hours.
Gregor is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
propduster8
General Electric Discussions
21
12-13-2012 02:42 PM
GooberRC
FMA Direct
2
10-05-2012 06:55 AM
Tim Marks
FMA Direct
63
09-21-2012 06:09 AM
liposucker
Batteries & Chargers
10
09-19-2012 03:58 AM
Jlbrad1
FMA Direct
3
02-11-2011 11:17 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Quick Reply: Pl6 safety code 96 at low current charge rates


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.04666 seconds with 12 queries