Futaba R617FS reciever hookup
04-17-2011, 09:37 AM
#1
New Member
Thread Starter
Join Date: Apr 2011
Location: Aiea, HI
Posts: 12
Futaba R617FS reciever hookup
Alright I am having trouble with setting up a Futaba R617FS reciever set-up in a Lanxaing f-16 EDF with thrust vectoring. My problem is this. The model comes pre wired with the BEC inline with the throttle. The throttle must be on channel 3 and the battery or BEC must be on channel 7. My TX is a 2.4ghz 7c also futaba and the aileron rudder throttle and elevator must stay on channels 1-4 channel 5 is retractable gear and channels 6 and 7 are used for the thrust vectoring. Does anyone know how or if it would be possible to get this setup to work?
04-17-2011, 05:51 PM
#2
Crash Specialist
Join Date: Oct 2009
Posts: 302
I am not sure I completely understand your problem but the BEC can plug into any open space on the receiver. If the BEC is already connected to channel 3 along with the ESC it should still work just like it was with the original receiver.
Mike
Mike
04-17-2011, 11:12 PM
#4
Crash Specialist
Join Date: Oct 2009
Posts: 302
Originally Posted by Apeman76
That would be true with most recievers however the futaba R617FS will only accept battery power on channel seven, or at least mine will only accept power on channel seven.
Mike
04-17-2011, 11:29 PM
#5
Crash Specialist
Join Date: Oct 2009
Posts: 302
K, I just checked 2 of my 617 receivers and they both worked with the BEC plugged into any slot.
I would think now the ESC is opto coupled and requires an alternate power source to work (BEC). We have a Ice 120HV that is that way. If you just plug in the ESC nothing has power and it will not arm until you plug in the BEC.
Mike
Pics might help if you can take some.
I would think now the ESC is opto coupled and requires an alternate power source to work (BEC). We have a Ice 120HV that is that way. If you just plug in the ESC nothing has power and it will not arm until you plug in the BEC.
Mike
Pics might help if you can take some.
04-18-2011, 01:16 AM
#6
Look out for that tree!!!
Join Date: Mar 2006
Location: Gig Harbor, Wa USA
Posts: 7,061
Yup - you can power those rx's on any channel. Its the same with virtually any receiver on the market. They all feed power to the servos on all the channels, so they can take it in the same way.
Even rx's that have dedicated "power" input slots can be fed on any channel.
Even rx's that have dedicated "power" input slots can be fed on any channel.
