Warbird Electrics Discuss e-powered warbirds in here!

Spitfire - offset rudder?

Old 12-02-2008, 11:14 PM
  #1  
easyflyer01
New Member
Thread Starter
 
Join Date: Jan 2008
Posts: 15
Default Spitfire - offset rudder?

I just received the Spitfire I ordered from Hobbyzone, and after assembling the wing and stab, I noticed that the rudder, which is non-movable, is offset to the left somewhat. Does anyone know if this is supposed to be like that, perhaps to offset the motor torque, or has it been damaged in shipping? I am hesitant to fly it until I find out from someone else if mine is okay. Appreciate any help!
easyflyer01 is offline  
Old 12-03-2008, 12:31 AM
  #2  
Bub Steve
Super Contributor
 
Bub Steve's Avatar
 
Join Date: Aug 2006
Location: Shadeville Fl,
Posts: 7,189
Default

It should be not be off-set, there someelse that ain't right, got any pix's??? bub, steve




[IMG]file:///C:/DOCUME%7E1/STEVEC%7E1/LOCALS%7E1/Temp/moz-screenshot.jpg[/IMG][IMG]file:///C:/DOCUME%7E1/STEVEC%7E1/LOCALS%7E1/Temp/moz-screenshot-1.jpg[/IMG]
Bub Steve is offline  
Old 12-03-2008, 12:36 AM
  #3  
Saucerguy2
Super Contributor
 
Join Date: Apr 2006
Posts: 1,893
Default

It will fly just fine even if the entire tail feather section is off, just going to be needing a little more trim, that's all. My favorite plane I assembled this spring was off at first, it didn't affect performance at all, I just wanted to fly it and didn't really care how well it did, just to be the first to do it in that particular design revision. I have it straightened up now, but just cause I have down time due to the weather, otherwise I would not have touched it.
Saucerguy2 is offline  
Old 12-03-2008, 01:47 AM
  #4  
easyflyer01
New Member
Thread Starter
 
Join Date: Jan 2008
Posts: 15
Default

Thanks for the info. Upon closer inspection, it appears the rudder assembly was bent at some time and then packed in a somewhat straighter condition. Creases show that it is weak, and I've tried to reinforce it with packing tape. Since I just got it yesterday, I called customer service at Hobbyzone and after a couple of questions, they said they would send out another fuselage. Can't beat that!
easyflyer01 is offline  
Old 01-08-2009, 10:16 PM
  #5  
JoeTheFlyer
The UK's Red Baron
 
JoeTheFlyer's Avatar
 
Join Date: Aug 2008
Location: UK
Posts: 78
Default

Lots of people have had this problem with the rudder, and also the horizontal stabilzer not being in alignment with the wings. I levelled out the stabilizer by cutting a pice of card out and wedging it in between the fuselage and the green plastic bit that you slide the stabilizer into. That's now ok. The rudder is also slightly to the left, but ive flown it with this and had no problems at all, some people like me just deal with it, others prefer to get a replacement.

Happy flying .
JoeTheFlyer is offline  
Old 01-11-2009, 07:11 PM
  #6  
dghutt
duckling
 
dghutt's Avatar
 
Join Date: Feb 2008
Location: Halifax, NS
Posts: 29
Default

My Spit arrived the same poor alignment. The last 4" of the fuse, vertical stab and all, are bent slightly to port with some creases in the skin suggesting it was bent in transit. Also virtually all the seams in the fuse's foam skin were open. I gorilla glued the seams, reinforced the wing, assembled and flew it anyway and can't say I really notice the rudder / tail issue in flight.

Good that PZ is sending a new fuse, but don't throw away the old one. It'll work if you need a replacement in future.

Dave
dghutt is offline  
Old 01-12-2009, 02:42 AM
  #7  
easyflyer01
New Member
Thread Starter
 
Join Date: Jan 2008
Posts: 15
Default

Thanks for the info. I still have the other fuselage, and.... well, I've needed it, as well as two new firewalls, cowls, spinners, and prop shafts!
I've flown my spits twice- the first for about a minute when for no apparent reason, it did a wing over and went staight in. I was using the low rate "A" mode on the transmitter, and I don't think I had enough throw in the ailerons to regain control.
After completely refitting the second fuselage, I tried again. This time, on the high rates, it flew quite well for one minute and 46 seconds!
Stupidity doomed it this time. I let it get behind me and into the sunset... I never even saw it hit the ground!
However, I have since rebuilt it yet again, and I am determined to fly it as soon as weather permits. Lots of fun and the rebuilds give me something to work on when conditions aren't good for flying. Love this hobby!
easyflyer01 is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
skyeye
Aerial Photography
5
03-25-2008 03:24 AM
John Boy
Hi-Performance and Sailplanes
26
02-08-2008 02:04 AM
nipper
ParkFlyers
10
11-09-2007 08:50 AM
adhoc
RC Radios, Transmitters, Receivers, Servos, gyros
2
06-07-2006 06:35 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Quick Reply: Spitfire - offset rudder?


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.07880 seconds with 15 queries